Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the Protective
Devices
Before any work on the machine itself, pull
the mains plug.
Protection Guard
For work with grinding or cutting discs, the
protection guard 6 must be mounted.
Place the guard 6 on the spindle collar. Adjust the
position of the guard 6 to the requirements of the
work process. Clamp with screw 7.
The closed side of the guard 6 must always
point towards the operator.
Auxiliary Handle
For all work with the machine, the auxiliary
handle 3 must be mounted.
Screw the auxiliary handle 3 on the right or left of
the machine head depending on the working
method.
Hand Guard
For work with the rubber sanding pad 13 or with
the cup brush 16/disc brush/flap disc, mounting
the hand guard 12 (accessory) is recommended.
The hand guard 12 is fastened with the auxiliary
handle 3.
Mounting the Grinding Tools
Before any work on the machine itself, pull
the mains plug.
Use only grinding tools with a permissi-
ble speed at least as high as the no-load
speed of the machine.
Grinding and cutting discs become very
hot while working; do not touch until
they have cooled.
Clean the grinder spindle and all parts to be
mounted. For clamping and loosening the
grinding tools, lock the grinder spindle 5 with
the spindle lock button 4.
Actuate the spindle lock button 4 only when
the grinder spindle is at a standstill!
Grinding/Cutting Disc
Pay attention to the dimensions of the grinding
disc. The mounting hole diameter must fit the
mounting flange 8 without play. Do not use re-
ducer pieces or adapters.
14
When using a diamond cutting disc, take care that
the direction-of-rotation arrow on the diamond
cutting disc and the direction of rotation of the ma-
chine (direction-of-rotation arrow on the machine
head) agree.
For mounting, see the illustration page.
Screw on the clamping nut 10 and tighten with the
two-pin spanner (see Section "Quick-clamping
Nut").
8
If the O-ring is missing or is damaged, it must
in
all
cases
be
1 600 210 039) before the mounting flange 8 is
mounted.
After mounting the grinding tool and be-
fore switching on, check that the grind-
ing tool is correctly mounted and that it
can turn freely.
Flap Disc
Depending on the application, remove the protec-
tion guard 6 and mount the hand guard 12. Place
the special mounting flange 8 (accessory, Order
No. 2 605 703 028) and the flap disc on the
grinder spindle 5. Screw on the clamping nut 10
and tighten with the two-pin spanner.
Rubber Sanding Pad 13
Depending on the application, remove the protec-
tion guard 6 and mount the hand guard 12.
For mounting, see the illustration page.
Screw on the round nut 15 and tighten with the
two-pin spanner.
Cup Brush 16/Disc Brush
Depending on the application, remove the protec-
tion guard 6 and mount the hand guard 12.
The grinding tool must be able to be screwed onto
the grinding spindle 5 until it rests firmly against
the grinder spindle flange at the end of the grinder
spindle threads. Tighten with an open-end span-
ner.
An O-ring (plastic part)
is inserted in the mount-
ing flange 8 around the
spigot.
replaced
(Order
No.
Publicidad
