Publicidad
Idiomas disponibles
Idiomas disponibles
Rotating the Machine Head
Before any work on the machine itself, pull
the mains plug.
Unscrew completely the four screws.
Rotate the machine head carefully and without
removing from the housing to the new position.
Screw in the screws again and tighten.
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be de-
graded. The use of a stationary extraction
system is recommended in such cases as
well as frequently blowing out the ventila-
tion slots and installing a residual current
device (RCD).
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for BTI power tools.
In all correspondence and spare parts orders,
please always include the 6-digit order number
given on the nameplate of the machine.
The machine head
can be rotated with re-
spect to the machine
housing in 90° steps.
In this manner, the
On/Off switch can be
brought to an advan-
tageous handling po-
sition for special work-
ing situations, e. g.,
for cutting work with
the cutting guide 18/
cutting
grinder
stand 19 (accessory)
or for left-handed per-
sons.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2 wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the earth
terminal of the plug.
Important: If for any reason the plug is cut off of
the cable of this machine, it must be disposed of
safely and not left unattended.
Environmental Protection
Recycle raw materials instead of disposing as
waste
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The plastic components are labelled for catego-
rized recycling.
To be fitted by qualified
professional only
® ®
17
Publicidad
