Publicidad
Idiomas disponibles
Idiomas disponibles
EN
BEFORE INSTALLING
1. Previous electrical installation must be correctly carried out.
2. In the pre-installation use cable suitable for swimming pools.
3. Use watertight connection products. It is advisable to use the waterproof connection box with power
strip ref.: 001105531 or a watertight connection handle ref.: 001105532.
4. Make sure that a 12V transformer suitable for swimming pool is installed before placing the surface
projector.
INSTALLATION
NOTE: Projector suitable to replace conventional or LED lamps.
WARNING: The projector needs a 12V transformer suitable for swimming pools, it is not included.
1. Mark the location of the holes of the four screws to fix the base of the projector. It should be placed
approximately 700mm from the upper edge of the pool, at least 400mm from the water. Install in areas that
are easily accessible. And ajugerear.
2. Screw the base of the projector onto the wall of the pool.
3. Fit the projector in its holder.
4. Fix the assembly with the small screw.
2
3
4
10 | www.garsaco.com
Publicidad
