IPC PW-H90 Hps-H Manual De Instrucciones página 23

USING
THE CLEANER
CONTROL PANEL
A - On/off switch
B - Temperature regulator
C - Detergent control tap (if
available).
D - Light indicating connection
to the mains/microleakages (if
available).
E - Burner ligth (if available).
F - Light indicating diesel oil
lack (if available).
G - No descaler indicator light (if available).
STARTING THE CLEANER
1) Turn on the water supply tap (fig. 4A).
2) Connect the water cleaner to the mains electricity supply via
the omnipolar switch or by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. 1
(fig. 6A).
!
Warning
The high pressure water jet generates a reaction force in the
lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) To use the cleaner with hot water, turn the temperature regu-
lator (fig. 6B) to the recommended washing values.
For some models turn the ignition switch (fig. 6A) onto the
hot water position before effecting the operations described
in this point.
!
Warning
In water cleaners with the "Total Stop" system, the motor starts
and stops when the lever on the lance handle is actioned or
released.
!
Danger
Do not block the handle lever in the delivery position.
IMPORTANT!
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfunc-
tion (Fig. 7).
English
USING THE ACCESSORIES.
The high pressure washer has a nozzle with a flat angle jet for
cleaning large surfaces.
ROTARY HEAD (optional accessory)
The high pressure washer can be fitted with a head with rotary
nozzle to clean the most stubborn dirt.
!
Danger:
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
Do not aim the jet at people, animals or electrical sockets.
FIG. 6
USE OF THE DOUBLE LANCE (fig. 9)
The double lance allows the operator to select a low or high
pressure jet. The pressure is selected with the gun in pos. 1.
High pressure: pos. 2. Low pressure pos. 3.
STOPPING THE CLEANER
1) Switch off the burner by
turning the pressure regulator
to pos. "0" (fig. 6B).
2) Let the cleaner run with cold
water only for at least 30 se-
conds to cool down the boiler.
3) After using with detergent,
flush out the intake circuit;
place the detergent suction
hose (fig. 8) in a tank of clean
water and let the pump run for
1 minute with the dosing tap
turned fully on and the lance in
detergent delivery condition.
4) Stop the cleaner by turning
the selector switch to pos. "0"
(fig. 6A).
5) Discharge the pressure
from the H.P. hose by pressing
the trigger on the gun (fig. 5A).
6)
Disconnect the water cle-
aner from the mains electri-
city supply via the omnipolar
switch or by unplugging the
plug from the socket.
7) Turn off the water supply
tap (fig. 4A).
!
Warning
- If the water cleaner is left,
even temporarily, turn it off by
using the omnipolar switch or
by unplugging the plug from
the socket.
- Water cleaners with the "Total
FIG. 7
Stop" device should be con-
- 23 -
FIG. 8
FIG. 9
FIG.10