Princess 242120 Manual De Instrucciones página 19

Setting Function
A OFF
B Hot water dispenser
C Milk froth dispenser
D Coffee dispenser
Adjusting the coffee dispenser
height (fig. F)
The height of the coffee dispenser can be
adjusted to meet your coffee-brewing
requirements.
• Turn the coffee dispenser (5) clockwise to
lower the coffee dispenser (fig. F1).
• Turn the coffee dispenser (5)
counterclockwise to raise the coffee
dispenser (fig. F2).
Making coffee with coffee pads
(fig. A, B, C, G & J)
Use conventional coffee pads with an outer
diameter of 7 cm.
Caution!
• Do not use the following types of coffee
pads:
- coffee pads with an outer diameter
smaller than 7 cm;
- hard coffee pads for espresso makers;
- coffee pads with additives for
cappuccino, etc.
• Do not put damaged coffee pads, loose
ground coffee or instant coffee into the
coffee pad cassette.
Caution!
• Follow the instructions below to put coffee
pads into the coffee pad cassette:
- Use the side marked '1' on the coffee
pad cassette for one cup of coffee.
Use the side marked '2' on the coffee
pad cassette for two cups of coffee.
- Lightly tap the coffee pad with your
fingertips to evenly distribute the ground
coffee in the coffee pad. Make a small
indentation in the centre of the coffee
pad.
- Put asymmetrical coffee pads in the
appliance with the flat side down.
- If you use two coffee pads at the same
time, firmly press the first coffee pad into
the recess of the coffee pad cassette
with the paper edge facing upwards.
Subsequently, put the second coffee pad
into the coffee pad cassette according to
the instructions above.
• Set the dispenser selector (4) to position 'A'.
• Remove the coffee pad cassette (9) from
the appliance.
• Put the coffee pad in the coffee pad
cassette (9).
- For one cup, put the coffee pad in the
side marked '1' on the coffee pad
cassette (fig. G1).
- For two cups, put the coffee pads in the
side marked '2' on the coffee pad
cassette (fig. G2).
• Insert the coffee pad cassette (9) into the
appliance with the coffee pad upwards.
Make sure that coffee pad does not shift.
• Place the required amount of cups under
the coffee dispenser (5).
- For one cup, place the cup under both
dispenser nozzles of the coffee
dispenser (fig. J1).
- For two cups, place one cup under the
left dispenser nozzle and one cup under
the right dispenser nozzle of the coffee
dispenser (fig. J2).
• Press the on/off button (1) to switch on the
appliance. The start/stop button (2) flashes
red. The start/stop button (2) becomes
green when the appliance is ready for use.
• Set the dispenser selector (4) to position
'D'.
• Set the cup size selector (3) to the required
position.
• Press the start/stop button (2).
• To interrupt the process, press the start/
stop button (2) again.
• If the process is completed, set the
dispenser selector (4) to position 'A'.
Making coffee with ground coffee
(fig. A, B, C, H, I & J)
Use 5.5 - 7.5 grams of ground coffee,
depending on the quality of the coffee.
• Set the dispenser selector (4) to position 'A'.
• Remove the coffee pad cassette (9) from
the appliance.
19