Publicidad
Idiomas disponibles
Idiomas disponibles
5) Replace drain plug.
6) Refill with VG 32 hydraulic oil until the level is between the min and max lines on the tank
(about 15 litres).
7) Refit the filter cup, install a new filter element and refit the black screw cap, to the filter
housing, ensuring o-ring remains in place.
NOTE: This is a non-adjustable air breather filter.
Grease the discharge flange
1) Remove the discharge tube.
2) Apply multipurpose grease to surface shown.
3) Refit discharge tube.
Engine servicing
All engine servicing must be performed in accordance with the Engine Manufacturer's handbook
provided with the machine.
Failure to adhere to this may invalidate warranty and/or shorten the life of the engine.
Check hoses
All the hydraulic hoses should be regularly inspected for chafing and leaks. The hydraulic system is
pressurized to 150 Bar and thus the equipment containing it must be kept in good condition.
Identify the hoses that run to the top motor. These have the highest chance of damage as they are
constantly moving. If any hydraulic components are changed new seals should be installed during
reassembly. Fittings should then be retightened.
Assembly
Set the shipping crate on a solid flat surface and carefully remove the lid. Use two people and take all
parts out of the crate and inspect the components to ensure there are on missing pieces before
starting to assemble the wood chipper.
1. Attaching the tires
1) Attach the torsion axle (43) to the chassis (1) using hex bolt M12x30 (141) and spring washer
12 (143).
2) Attach the wheel (38) to the torsion axle (43) using flange spherical nut Q30812T13 (173).
Publicidad
