Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARING FOR USE
1. Wash reservoir and lid before use according to cleaning instructions on page 4.
CAUTION: Do not plug unit in without filling reservoir with water first.
2. Remove lid and add water to the reservoir. Water level must always remain between
the MIN and MAX fill lines.
3. Replace lid on top of reservoir. Replace water after 24 hours or when water is depleted
(whichever comes first).
WARMING
1. Once water is added to reservoir as outlined in steps 1-3 of Preparing for Use, plug in power
cord. The Insta-Prep™ turns on as soon as it is plugged in.
2. Press
Temperature Control Button until you reach your desired water temperature.
A. Blue - room temperature, no heat
B. Yellow - around body temperature
C. Red - slightly above body temperature
NOTE: The indicator light blinks slowly while the water is warming and turns solid once
it has reached the desired temperature. The indicator light blinks quickly when the water
temperature is above the desired temperature and needs to cool.
Depending on the starting temperature of the water added to the reservoir,
it could take 10-20 minutes to warm to the desired temperature.
3. Press
Light Button to turn the light on or off.
4. Place bottle in bottle holder, centering it as much as possible.
5. Press down on the water dispenser to fill bottle with water and release to stop
dispensing water.
6. Add formula powder to bottle. Always follow formula manufacturer's instructions
for preparation.
CAUTION: ALWAYS TEST CONTENT TEMPERATURE BEFORE FEEDING YOUR BABY.
TROUBLESHOOTING
If the warmer is not operating, check that:
A. The power cord is connected to the power outlet.
B. Water has been added to the reservoir.
CLEANING
CAUTION: Unplug from outlet and allow to cool before cleaning.
DO NOT IMMERSE IN WATER.
NOTE: DO NOT use bleach, scouring pads, abrasive cleaners, or solvents for cleaning.
Water Reservoir and Lid: Before each use, hand wash with warm, soapy water, rinse,
and dry thoroughly.
CAUTION: Water reservoir is glass. Handle with care.
Base: Wipe with damp cloth or sponge.
4
Publicidad
