Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Installation of the ball bar:
1.)
Remove the plug from the receiver.
The ball bar is usually in the unlocked position when it is removed from the boot of the vehicle. This is the
case if there is a visible gap of approx. 5 mm between the handwheel and the ball bar (see diagram) and the
red marking on the handwheel is aligned with the green marking on the ball bar.
Please note that the ball bar can only be inserted in this state!
If the locking mechanism of the ball bar has, for some reason, been disengaged before installation, i.e. the
ball bar is in the locked position, the mechanism has to be pre-tensioned. The locked position is easily
identifiable as the green marking on the handwheel is aligned with the green marking on the ball bar and
there is no gap between the handwheel and the ball bar (see diagram).
Follow the instructions below to pre-tension the locking mechanism:
Insert key and open lock, extract the handwheel in the direction of arrow a, and turn it until the limit stop in
the direction of arrow b.
The release ball is pre-tensioned and, after the handwheel is released, the locking mechanism remains in the
pre-tensioned position. / The release lever will engage and, after the handwheel is released, the locking
mechanism remains in the pre-tensioned position.
2.)
Install the ball bar together with the stop pin by inserting and pushing both into the receiver.
The locking operation is performed automatically in this case.
Always keep hands away from the handwheel because it rotates during the locking process.
3.)
Close the lock and always remove the key. The key cannot be withdrawn if the lock is open! Press the cover
onto the lock.
Removal of the ball bar:
1.)
Pull the cover off the lock and press it onto the handle of the key.
Open the lock with the key.
2.)
Hold the ball bar, extract the handwheel in the direction of arrow a, and turn it until the limit stop in the
direction of arrow b in order to unlock it in the extracted position.
Remove the ball bar from the receiver.
The handwheel can now be released; it automatically engages in the unlocked position.
3.)
Stow the ball bar in a safe place in the boot of the vehicle and protect it against dirt.
4.)
Insert the plug into the receiver!
Notes!
Any repairs or dismantling of the detachable ball bar should only be carried out by the manufacturer.
Fix the enclosed information plate to the car close to the receiver or inside the boot where it is clearly visible.
Always keep the ball bar and the receiver clean to ensure proper operation.
Ensure regular servicing of the mechanical parts. Treat lock only with graphite.
Lubricate the bearing points, friction surfaces and balls with resin-free grease or oil. Grease and oil also function as
additional protection against corrosion.
The ball bar has to be removed and the plug inserted when cleaning the car with a steam jet cleaner. The ball bar
must not be cleaned with a steam cleaner.
Important!
2 keys are issued with the detachable ball bar. Make a note of and keep the key no. ???? in case of repeat orders.
28
28
? ? ? ?
313 204 691 101 - 002
Publicidad
