Publicidad
Idiomas disponibles
Idiomas disponibles
FCC Compliance (cont.)
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could void the
users authority to operate the equipment.
Care and Cleaning
For best results, keep the following in mind when caring for your Kallista product:
General Cleaning - Use a mild detergent such as liquid dishwashing soap and warm water for cleaning.
Rinse well to remove all detergent and gently dry. Do not use abrasive cleaners that may scratch or dull the
surface.
Read Labels - Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
Test First - Always test your cleaning solution on an inconspicuous area before applying it to the entire
surface.
Do Not Let Cleaners Soak - Do not allow cleaners to sit or soak on the product.
Wipe Clean - Wipe surfaces clean and rinse completely with water immediately after cleaner application.
Rinse and dry any overspray that lands on nearby surfaces.
Avoid Abrasive Materials - Use a soft, dampened sponge or cloth. Never use an abrasive material such as a
brush or scouring pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kallista.com/tools_and_resources.html.
For additional assistance, please contact Kallista Customer Service at 1-888-4-KALLISTA (1-888-452-5547).
Cleaning Your User Keypad and Remote Control
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty,
use a non-abrasive soap and warm water to clean.
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following sequence:
Turn the jet trim rings fully clockwise to remove air induction.
Fill the whirlpool with warm water to a level at least 2" (5.1 cm) above the highest jets, or leave
water in the whirlpool after using.
Add 2 tablespoons (30 ml) of a low-foaming dishwasher detergent and 20 ounces (590 ml) of
household bleach (5% - 6% sodium hypochlorite) to the water.
Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
If desired, rinse the bath surfaces with water.
Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.
1034059-5-C
6
Kallista
Publicidad
