Publicidad
Idiomas disponibles
Idiomas disponibles
Remote control batteries
Pepare the Remote Control
The provided Remote Control allows the unit to be
operated from a distance.
Even if the Remote Control is operated within the
effective range (6m), remote control operation may
be impossible if there are any obstacles between the
unit and the remote control.
If the Remote Control is operated near other
products which generate infrared rays, or if other
remote control devices using infrared rays are used
near the unit, it may operate incorrectly.
Conversely, the other products may operate
incorrectly.
Replace the Remote Control Battery
1. Use needle to push the battery forward through the
hole on rear of remote control.
2. Use needle to remove the old battery. Place a
new CR2025 battery with correct polarity (+/-) as
indicated. Then install the battery into remote control.
Precautions Concerning Batteries
When the Remote Control is not to be used for a
long time (more than a month), remove the battery
from the Remote Control to prevent it from leaking.
If the batteries leak, wipe away the leakage inside
the battery compartment and replace the batteries
with new ones.
Do not use any batteries other than those specified.
Do not heat or disassemble batteries. Never throw
them in fire or water.
Do not carry or store batteries with other metallic
objects. Doing so could cause batteries to short
circuit, leak or explode.
Never recharge a battery unless it is confirmed to
be a rechargeable type.
All manuals and user guides at all-guides.com
Play
Encender el sistema
Press the
standby mode.
Note:
The set will switch to last selected source.
Turning the System Off
Press
to Eco power mode.
Nota: Asegúrese de desenchufar el cable de
alimentación de la toma de corriente cuando el
sistema no esté en uso durante un largo período de
tiempo.
Play iPod/iPhone/iPad
You can enjoy audio from iPod/iPhone/iPad through
this unit.
1. Press the
the Remote Control to select DOCK source.
2. iPod/iPhone/iPad support raise up after place an
iPod/iPhone/iPad to the dock (If you want to raise up
or lower the support, press the
Function button on the Remote Control)
3. Start to play the connected iPod/ iPhone/iPad.
- To pause/resume play, press the
- To skip to a track, press the
- To search during play: press and hold
buttons, then release to resume normal play.
- To navigate through the menu: hold and press M
button, then press
confirm.
Note: When you use
menu, the interval between each operation should be
within 5 seconds, or it will return to normal function.
button to turn the system on from
button again to turn the system off and go
button on unit or Function button on
button on unit or
,
to select, and press
,
to navigate through the
button.
buttons.
to
15
Publicidad
