Additional Functions - TYPHOON H Manual De Instrucciones

ADDITIONAL FUNCTIONS:

TASK MODES
Tap the TASK/CAMERA icon, the background of 'TASK' will become orange, then
you will enter another interface displaying functions: CCC (Curve Cable Cam),
Journey, POI (Point of Interest), ORBIT ME and TAKE OFF.
CCC: (Curve Cable Cam) Curve Cable Cam allows you to create an invisible
route for Typhoon H to fly along. Once the pilot sets the point, Typhoon H
will fly the set coordinates while remembering the heading.
If the PAN mode of the gimbal camera is switched to Follow and Follow Pan
Controllable modes, the gimbal TILT angle will be adjusted as the same as the
angle what the gimbal camera is at each waypoint after the pilot set the waypoints
automatically and continuously. When the PAN mode is switched to the Global
Mode, the PAN and TILT angle can be controlled by aileron and elevator stick.
NOTICE: The direct distance between every two waypoint should be more than 5 meters.
Model: Typhoon H
VOLTS
CCC
N/A
PONINT 1 PONINT 1
PONINT 2
GPS
PONINT 3
N/A
INSTRUCTION
SAT
N/AE
RESET: Delete all waypoints
N/AN
obstacles before starting mission.
+/-: Add/Delete a waypoint
POS
LIST: Load existing waypoint
N/AV
SAVE: Save waypoint
ALT
START: Start waypoint mission
N/Am
G-SPD
N/A KPH
BACK RESET
DIS
N/Am
Pad System Settings
welcome,Pilot 12:27 AM
Make sure the H is clear of all
SLIDE TO START
CANCEL
LIST SAVE
START
Channel Settings
Tap the CCC to enter the Curve Cable Cam function.
BACK RESET
BACK: Tap BACK and you can return to the previous interface.
RESET: Tap RESET to delete all the points created during the flight.
: Tap '-' to delete the last point created during the flight.
: Tap '+' to create a new point recording the current flying position.
LIST: Tap LIST and all previous routes saved will be shown on a list. You can delete
any saved route by sliding the chosen one to the left.
SAVE: Tap SAVE and the current route will be saved.
START: Tap START, and slide the icon. Typhoon H will fly back to waypoint 1
automatically.
[ ]: When the pilot tap the [
will be paused. When tap it again, the [ ] will become [ ], the copter will continue
the CCC function. The pilot can exit the function by tapping EXIT icon or switching
flight mode.
12
G
ANGLE
OBS
Disabled
GPS
CALIBRATION
FOLLOW
WATCH
TASK
CAMERA
Model Select
11
LIST SAVE START
]， the icon will become [ ]and the CCC function