Keysight EDU33210 Serie Manual De Instrucciones página 50

Remote Control
You can control the instrument via SCPI with Keysight IO Libraries or via a simulated front panel with the
instrument's Web interface.
Web Interface
You can monitor and control the instrument from a Web browser by using the instrument's Web interface. To
connect, simply enter the instrument's IP address or hostname in your browser's address bar and press Enter.
If you see an error indicating 400: Bad Request, this is related to an issue with "cookies" in your Web browser. To
avoid this issue, either start the Web interface by using the IP address (not hostname) in the address bar, or clear
cookies from your browser immediately before starting the Web interface.
The Configure LAN tab on the top allows you to change the instrument's LAN parameters; exercise caution when
doing so, as you may interrupt your ability to communicate with the instrument.
When you click the Control Instrument tab, the instrument will ask you for a password (default is keysight), and then
it will open a new page, shown below.
50 Keysight EDU33210 Series User's Guide