Publicidad
Idiomas disponibles
Idiomas disponibles
In order to print, you must first create a media profile, and you must have at least
one printer connected to the scanner over a network.
1.
Check that the media profile you intend to create does not already exist in the
media profile list. If the media profile you want to create already exists, you
must delete the existing one first before you can install it again.
2.
Clean and calibrate the scanner, unless that has already been done recently.
See
3.
Start media profile creation by selecting the Setup tab.
4.
Tap the Media Profile button, then tap the Tool button. (Alternatively: Printer >
Tool > Media Profile).
5.
If you see a Calibrate RIP button and would like to use it, refer to the online
help.
6.
Select the paper type that you have loaded in the printer.
7.
When you are warned that no media profile exists for that paper type, tap OK.
8.
Tap the Print Color Sheet button to print a color-patch reference sheet. Some
printers print a special test sheet, which you can discard, before printing the
color sheet.
9.
Tap the Scan Sheet button to scan the color sheet.
10.
Load the color sheet into the scanner. Align the arrow on the color sheet with
the arrow on the center of the scanner.
11.
Tap the OK button to start the scan.
12.
When you see a message confirming that the media profile has been
created, tap OK.
Make copies
If you have a printer, you can use the scanner and the printer to make photocopies.
1.
Select the Copy tab and insert your document.
a.
b.
6
Chapter 1 HP SD/HD Pro 2 44-in Scanner Introductory Information
Scanner maintenance on page
Place the document with the image facing up and the top edge forward
in the scanner insertion slot. Align the center of the document with the
center of the insertion slot.
Adjust the paper guides to the paper width so that the paper is aligned
as it feeds into the scanner.
10.
Publicidad
