Hotpoint Ariston KIO 632 CC S Manual De Instrucciones página 15

4. Set the cooking duration using the
buttons.
5. Confi rm by pressing the
selection occurs after 10 seconds.
The timer begins counting down immediately.
A buzzer sounds for approximately 1 minute and the
cooking zone switches off when the set programme has
fi nished.
Repeat the above procedure for each hotplate you wish
to programme.
Using multiple programmes and the display
If one or more hotplates are programmed, the display
will show the data for the hotplate with the least time
remaining, and the light corresponding to the position of
the hotplate will fl ash. The lights corresponding to the
other hotplates programmed will be switched on.
To visualise the time remaining for the other
programmed hotplates, press the
repeatedly: the time remaining for each hotplate will be
shown sequentially in a clockwise order,
starting from the front left hotplate.
Changing the programme
1. Press the button repeatedly until the duration
you wish to change is shown.
2. Use the buttons to set the new duration.
3. Confi rm by pressing the
To cancel a programme, follow the above instructions.
-
At step 2, press the button: the duration decreases
progressively until it reaches 0 and switches off. The
programme resets and the display exits programming
mode.
Timer
The hob must be switched on.
The timer can be used to set a duration up to 99
minutes.
1. Press the programming button until the timer
indicator light is illuminated
2. Set the desired duration using the
3. Confi rm by pressing the
The timer begins counting down immediately. When the
time has elapsed, a buzzer will sound (for one minute).
- +
and
button or automatic
button
button.
.
- +
and buttons.
button.
Control panel lock
When the hob is switched on, it is possible to lock the
oven controls in order to avoid accidental changes
being made to the settings (by children, during cleaning,
etc.). Press the button to lock the control panel:
the indicator light above the button will switch on.
To use any of the controls (e.g. to stop cooking), you
must switch off this function. Press the
few moments, the indicator light will switch off and the
lock function will be removed.
Switching off the hob
Press the button to switch off the appliance - do not
rely solely on the pan sensor.
If the control panel lock has been activated, the controls
will continue to be locked even after the hob is switched
on again. In order to switch the hob on again, you must
fi rst remove the lock function.
"Demo" mode
It is possible to set the hob to a demonstration mode
where all the controls work normally but the heating
elements do not switch on. To activate the "demo" mode
the hob must be switched on, with all the hotplates
switched off.
+
• Press and hold the and
for 6 seconds. When the 6 seconds have elapsed,
the ON/OFF and CONTROLS LOCKED indicator
lights will fl ash for one second. Release the
-
buttons and press the
• The display will show the text DE and MO and the
hob will be switched off.
• When the hob is switched on again it will be set to
the "demo" mode.
To exit this mode, follow the procedure described
above. The display will show the text DE and OF and
the hob will be switched off. When it is next switched
on, the hob will function normally.
button for a
-
buttons simultaneously
+
and
button;
15
GB