Hilti VC 5-A22-L Manual De Instrucciones Original página 24

All manuals and user guides at all-guides.com
6.2 Changing the filter mat
1. Press the button to release the discharged-air filter and remove the filter support.
2. Remove the filter mat from the filter support.
3. Attach a new filter mat to the filter support.
4. Fit the filter support to the appliance.
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault
The battery does not engage
with an audible double click.
1 LED flashes.
The device does not work.
4 LEDs blink.
Reduced suction
performance.
18 English
Printed: 30.01.2018 | Doc-Nr: PUB / 5397505 / 000 / 00
6
Possible cause
The retaining lugs on the battery
are dirty.
The battery is discharged.
The battery is too hot or too cold.
The motor has overheated.
The waste material container is full. ▶ Empty the waste material
The suction hose or nozzle is
blocked.
The filter is clogged.
Action to be taken
▶ Clean the retaining lugs and
push the battery in until it
engages.
▶ Change the battery and charge
the empty battery.
▶ Allow the battery to cool down
or warm up slowly to room
temperature.
▶ Switch the appliance off.
▶ Wait 10 minutes.
▶ Remove the blockage or clean
the filter, intake connector, hose
or exhaust air filter.
▶ Switch the appliance on.
container.
▶ Clean the suction hose and
nozzle.
▶ Clean the filter. → page 17
▶ Change the filter. → page 17
2202256
*2202256*