Publicidad
Idiomas disponibles
Idiomas disponibles
other liquids.
25. Keep end of hose, wands and other openings
away from your face and body.
26. Do not use the cleaner to clean your pets or any
animal.
27. Keep the head (eyes, ear, mouth, etc.) away
from the openings, when the cleaner is working or
plugging.
WARNING:
Important:
If the suction openings of the unit, the hose or the
tube are blocked, switch off the vacuum clearer and
remove the blocking substance before you start the
unit again.
1. Do not operate the vacuum cleaner too close to
hearter or radiators.
2. Before inserting the power plug into the wall
outlet, make sure that your hands are dry.
3. Before you start the unit, make sure to remove
large or sharp objects that might damage the dust
tank and hose.
4. When pulling out the power plug from the wall
outlet, pull the plug not the power cord.
5. Do not use without all filters in place.
6. When using, if you learn of squeak from the
cleaner, it must be suction appears to be reduced,
so you must stop (make sure the cleaner is not
plugging), then clean the all air filter.
Note:
If the supply cord is damaged, it must be replaced by
manufacture, its service agent or similarly qualified
person in order to avoid a hazard.
WARNING:
Hold the plug when rewinding the cord. Do not allow
the cord to whip when rewinding.
Use and function
Assembling vacuum cleaner
Note:
Always remove the power plug from the wall outlet
before assembling or removing accessories.
1. Attaching the Flexible Hose into the vacuum
connect the flexible hose into the air intake duct,
twist in until you hear a "click", indicating it is in its
locked position.
2. Fitting the tube to the curved wand/hose
extension.
Fitting the Floor Brush to the tube. Push the tube
into the floor brush. Adjust the tube to the desired
length.
Note:
Once all attachments are in place, unwind a sufficient
length of cable and insert the plug into the wall
outlet. A yellow mark on the power cord shows
the ideal cable length. Do not pull the power cord
beyond the red mark..
1. Insert the power plug into the wall outlet.
2. Press the power on/off button located the unit to
turn the vacuum cleaner "on".
3. To rewind the power cord, press the cord rewind
button with one hand and guide the power cord
with the other hand to ensure that it dose not whip
causing damage or injury.
Publicidad
