cecotec CONGA ANIMAL X Manual De Instrucciones página 52

ENGLISH
- Attach the mop to the mop holder and the latter to the robot vacuum cleaner.
- Select the scrubbing level on the remote control. There are two scrubbing levels: Low and
High.
- Once the desired scrubbing level has been selected, the robot vacuum cleaner will enter All
in One mode to simultaneously vacuum, scrub, sweep, mop, and dry.
Note
- If you only wish to mop, do not fill the water tank.
- If the tank is full, the robot vacuum cleaner will rotate on its own to moisten the mop as it
leaves the base.
- To ensure perfect mopping right from the start, it is recommended to evenly dampen the
mop before fixing it in place. It is also recommended to wash the mop after every use.
- It is recommended to be present when the robot vacuum cleaner is scrubbing.
- When the robot vacuum cleaner returns to the charging base, you must remove the mop.
Do not leave the robot vacuum cleaner charging with the mop assembled.
Back Home mode
Press the Back Home button on the robot vacuum cleaner or on the remote control in order
to send the robot to the charging base. The robot vacuum cleaner will stop vacuuming until it
reaches the base.
Manual mode
Use the directional arrows on the remote control to manually control your robot vacuum
cleaner.
Power Level function
Select the power level on the remote control to control the robot suction power level during
cleaning. There are 2 suction power levels: Eco and Normal.
5. CLEANING AND MAINTENANCE
Dirt tank. Fig. 8
- Lift the top cover of the robot vacuum cleaner and remove the dirt tank.
- Open the tank by unlocking the side flap and empty it.
High-efficiency filter. Fig. 9
- The high-efficiency filter is designed with fibres that help trap dust particles, dust mites,
pollen... It is very important to periodically clean the filter, to prevent these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
52
CONGA ANIMAL X