cecotec CONGA ANIMAL X Manual De Instrucciones página 54

ENGLISH
- It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
35 hours of operation or less.
Cleaning the drive wheels and the omnidirectional wheel Fig. 11
Use a clean, dry, soft cloth to wipe dust off the drive wheels and the omnidirectional wheel
located on the bottom of the robot vacuum cleaner.
Changing the cotton filter. Fig. 12
Remove the silicone plug from the bottom of the water tank.
1.
2. Remove the cotton filter from the silicone plug.
3. Replace the cotton filter with a new one and refit the silicone plug in the tank.
Charging base. Fig. 13
Use a clean, dry, soft cloth to wipe dust off the infrared lens and charging terminals. It is
recommended to clean them once a month.
Charging and replacing the battery. Fig. 14
- To lengthen the battery shelf life, leave the robot vacuum cleaner to charge in the charging
base when not in use.
- Remove the battery and store it in a safe, dry place if the robot vacuum cleaner will not be
used for a long period of time.
To replace the battery, follow the instructions below:
1. Unscrew the screws on the battery compartment, remove the battery cover, and the
battery itself.
Insert the new battery with the battery label facing up.
2.
Put the battery and the battery cover in back in place and properly fix the screws back
3.
again.
6. TROUBLESHOOTING
Beeps Error
1 Low battery
Drive wheel fault.
2 Side brush error.
54
CONGA ANIMAL X
Solution
Place the robot in the charging base.
Check if the drive wheel is blocked.
Check if the side brushes are blocked and clean them.