Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT:
Apply finish to this dresser prior to assembly. Before doing so, read the enclosed finishing hints.
NOTE: More than one type of hardwood is used, so test for the color you desire.
Test for desired color on:
a. Veneer parts—apply stain to the unexposed portion of a side panel. See Figure 1a.
b. Alder pieces—apply stain to the back of the base. See Figure 6.
Tools Required: Phillips Screwdriver, Tape Measure, Mallet or Rubber Hammer, Wood Glue
Fig. 1a
Gb
V2
V2
V2
STAIN TEST AREA
READ THE ENCLOSED INSTRUCTIONS ON HOW TO OPERATE THE CAM LOCK SYSTEM.
1. Using #6 x 5/8" Undercut (type 17) Screws (R), install three Drawer Slides (Cabinet Side Left) (V2)
in the three sets of pre-punched holes in the Left Side (Gb). The slides should be flush with the front
edges of the sides. Insert a third screw in one of the center holes in each of the slides. See Figure 1a.
Repeat for the Right Side (Hb) with Drawer Slides (Cabinet Side Right) (V1).
Hammer Tack Glides (Q) into the bottom edges of both sides about one inch from the back edge.
See Figure 1a.
Insert a Cam Connector (M) into each of the four holes in the underside of the Top (J). See Figure 1b.
586Wd — Page 4 — 03/14
586Wd Palmer 6-Drawer Dresser
Assembly Instructions
R
R
R
R
R
R
Q
Q
The side panels have a
compression stamp on the
bottom edge:
"L" for left, "R" for right.
Hb
V1
M
V1
J
V1
The drawer slides will be stamped with an "L" for left or
an "R" for right in the center of the wheels. Or they will be
stamped about 3" from the wheel with: "CL" for cabinet
Left; "DL" for drawer left; "CR" for cabinet right; "DR" for
M
Fig. 1b
drawer right.
Publicidad
