Publicidad
Idiomas disponibles
Idiomas disponibles
WALL MOUNTING
WARNING! All three screws with washers MUST
be used when installing mounting bracket.
Eliminating one or more of the supplied hex
head screws may allow bracket to detach
allowing reel to fall causing damage to
vehicles, injury or death.
1. Choose the approximate location for the reel within
2⁄' of a 110-125V standard ground outlet.
2. Locate a stud to install the mounting bracket. The
bracket will be placed against the wall vertically,
directly over the center of the stud.
3. Using the bracket as a template, mark the three
screw locations with pencil. (See Figure 1)
Figure 1
2⁄"
Bracket Hole Pattern
4. Pre-drill (pilot holes) the three screw holes with the
use of at 1/4" drill. The depth of the pilot holes should
be at least 2".
5. Install the bracket with the three provided hex head
wood screws with washers using a 1/2" wrench or
socket. Tighten all three until snug. (See Figure 2)
Figure 2
Bracket
PAGE 2 OF 12
INSTALLATION
2⁄"
Hex Head
Wood Screws
6. The reel can now be installed into the bracket. The
following installation instructions will allow smooth
retraction:
a. When the mounting height is less than 5', the reel
should be positioned so that the cord opening
face upward. (See Figure 3)
Figure 3
Wall
Figure 7
Locking
Pin
b. When the mounting height is more than 5', the
cord opening should face downward.
(See Figure 4)
Figure 4
Wall
Locking
Pin
7.
Slide the mounting pin through bracket and reel.
Slide the locking pin through the mounting pin for
security. (See Figures 3-4)
Mounting Pin
Cord
Opening
Mounting Pin
Cord
Opening
0623 IH-5644
Publicidad
