Cutter Blade Assembly And Disassembly And Adjustment Of Cutter Blade Height - Metabo HPT P 18DSL Instrucciones De Seguridad Y Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
(5) As shown in Fig. 23, 24, insert a turned portion of set
plate (A) attached to set plate (B) into a groove on the
fl at portion of the cutter block.
Flat portion of the cutter block
Groove
(6) As shown in Fig. 25, place the blade holder on the
completed assembly and fasten it with the three bolts.
Ensure that the bolts are securely tightened. Follow
the same procedures for the opposite side carbide
blade.
Bolt
CUTTER BLADE ASSEMBLY AND
DISASSEMBLY AND ADJUSTMENT OF
CUTTER BLADE HEIGHT
WARNING
● To prevent accidents, ensure that the power tool
is switched off and pull out the battery.
● Be careful not to injure your hands.
16
Set plate (A)
Fig. 23
Fig. 24
Blade holder
Fig. 25
1. Cutter blade disassembly
(1) As shown in Fig. 26 use the accessory box wrench
to withdraw the three bolts used to retain the cutter
blade, and remove the cutter blade holder.
Blade holder
(2) As shown in Fig. 27, slide the blade in the direction
indicated by the arrow to disassemble the blade.
2. Cutter blade assembly
CAUTION
Prior to assembly, thoroughly wipe off all swarf
accumulated on the cutter blade.
(1) Insert a turned portion of set plate (A) attached to the
blade into a groove on the fl at portion of the cutter
block. (Fig. 28, 29)
Set the blade so that both sides of the blade protrude
from the width of the cutter block by about 3/64"
(1 mm) (Fig. 30)
Flat portion of the cutter block
Box wrench
Fig. 26
Set plate (B)
Fig. 27
Set plate (A)
Fig. 28

Publicidad

Tabla de contenido
loading

Tabla de contenido