Use; Before Machine Start-Up - Clarke Vantage 17 E Instrucciones De Uso

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see Visible Symbols On
The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Use either the brush (42) or the pad-holder (43 and 44) according to the type of floor to be cleaned.
1. Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Place the brush (42) or the pad-holder (43 and 44) under the deck.
4. Lower the deck (10) by using the handlebar (2).
5. Connect the power supply plug (21) to the electrical mains.
6. Turn the switch (52) to "I".
7. Press the brush enabling push-buttons (51) to engage the brush/pad-holder to the deck hub (10). If necessary, repeat the
procedure until the brush/pad-holder is engaged.
Available brushes and their relevant application guides (suggestions only)
Models
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing
Marble
Vinyl tiles
Squeegee installation
8. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank filling
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
WARNING!
When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle floor cleaning detergents, wear suitable gloves and protections.
9. Use the filler neck (35) to fill the tank (28) with a solution suitable for the work to be performed. Do not fill the solution tank
completely, leave few inches from the edge. Always follow the dilution instructions on the label of the chemical product used to
prepare the solution. The solution temperature must not exceed 104 °F (40 °C).
12
INSTRUCTIONS FOR USE
VANTAGE 17 E - 9099653000
MIDLITE GRIT 180 MIDGRIT 240 PROLITE UNION MIX