Publicidad
Idiomas disponibles
Idiomas disponibles
PIPA RELX
™
Using Rigid Latch (Lower
Anchors) (continued)
1
- Check installation by pulling on
the base AND seeing that green
is indicated on the connectors.
2
-
The rigid latch must be
attached and locked onto the
vehicle anchor bars with the
indicator showing green. If
used, the stability leg indicator
must show green.
Retracted Positions
3
- There are three positions to
which the bottom of the base
retracts. In some vehicles, this
is necessary to allow the base to
sit against the vehicle seat back.
4
- If there is a gap between
the back of the base and the
vehicle seat after the rigid
latch lower anchors have been
attached, push on the top and/
or back of the base until it
touches the vehicle seat and a
"click" indicates it's locked into
a retracted position.
A gap is acceptable if the base
clicks through all retracted
positions but is still not fully
against the vehicle seat.
(continued on the next page)
40 PIPA lite rx instructions
Base Installation
1
2
3
1
2
3
4
PIPA lite rx instructions
41
Publicidad
