Publicidad
Idiomas disponibles
Idiomas disponibles
13. ALWAYS USE SAFETY GLASSES. Also use face or dust mask for commercial
cutting operations. Everyday eyeglasses only have impact-resistant lenses, they
are NOT safety glasses.
14. SECURE WORK. Use clamps or a vise instead of your hand to hold work when
practical. This safety precaution allows for proper tool operation using both hands.
15. DON'T OVERREACH. Keep proper footing and balance at all times.
16. MAINTAIN TOOLS WITH CARE. Keep tools clean and in good working condition
for maximum safety performance. Follow instructions for lubricating and changing
accessories.
17. DISCONNECT TOOLS BEFORE SERVICING – when changing accessories, such
as blades, bits, cutters, etc.
18. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in OFF
position before plugging in.
19. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recom-
mended accessories. The use of improper accessories may increase risk of injury.
20. MAKE SURE YOU USE THE CORRECT TOOL for the job you are doing.
21. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the
cutting tool is unintentionally contacted.
22. CHECK DAMAGED PARTS. Before further use of the tool, damaged part(s), (i.e.,
guard) should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of mo-
ving parts, breakage of parts, mounting and any other condition that may affect the
tools operation. A guard or other part that is damaged should be properly repaired
or replaced.
23. Replace damaged wheels/cutters immediately.
DO NOT USE DAMAGED WHEELS/CUTTERS. They may cause bodily injury.
24. DIRECTION OF FEED. Feed work into the wheel/cutter against the direction of
rotation of the wheel/cuter only.
25. DO NOT ALTER THE PLUG OR USE A 2-PRONG RECEPTACLE. This tool is
equipped with a 3-prong electrical plug.
26. NEVER LEAVE TOOL RUNNING UNATTENDED.
Turn power off. Don't leave tool until it comes to a complete stop.
27. Double Insulated tools are equipped with a polarized plug (one blade is wider than
the other). This plug will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified elec-
trician to install a polarized outlet. Do not change the plug in any way. Double Ins-
ulation eliminates the need for the three wire grounded power cord and grounded
power supply system.
This power tool is supplied with all the relevant safety guards and features, it should be
checked before every operation, this manual should be read and kept in a safe place.
Whilst we warn of all the possible risks attached to using power tools any operator must
have read and understood the manual and apply their own caution and common sense
when using this power tool.
7
Publicidad
