Stiga EW 330 Manual De Instrucciones página 16

3.1.2 Improper use
Any other usage not in keeping with the afore-
mentioned ones may be hazardous and harm
persons and/or damage things. Examples of
improper use may include, but are not limited to:
• Allowing children, animals or other passengers to
ride on the machine as they could fall off and injure
themselves or compromise safe driving by the operator.
• Letting oneself be transported by the machine.
• Using the machine to tow or push loads.
• Using the cutting means on surfaces other than grass.
• Using of the machine for leaf or debris collection.
• Using the machine to trim hedges, or for
cutting vegetation other than grass.
• Using of the machine by more than one person.
IMPORTANT Improper use of the machine will
invalidate the warranty, relieve the Manufacturer from
all liability, and the user will consequently be liable for
all and any damage or injury to himself or others.
3.1.3 User types
This machine is intended for use by consumers, i.e. non-
professional operators. It is intended for "DIY" use only.
IMPORTANT The machine must
be used by one operator.
3.2 SAFETY SIGNS
The machine has various symbols on it (Fig.2). They are
used to remind the operator of the behaviour to follow
to use it with the necessary attention and caution.
Meaning of symbols:
Warning. Read the instructions
before operating the machine.
Danger! Risk of thrown
objects. Keep all persons away
from the work area whilst working.
Be careful when using the
sharp cutting means. The
cutting means continues to
turn even after the motor has
been switched off. Disconnect
the plug from the mains before
commencing maintenance work
or if the power cable is damaged.
Warning. Keep the power cable
away from the cutting means.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service centre.
3.3 IDENTIFICATION LABEL
The identification label holds the following data (Fig.1):
1. Sound power level
2. Conformity marking
3. Month / Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
Article code
7.
8. Motor nominal power and maximum operating speed
9. Weight in kg
10. Power voltage and frequency
11. Electrical protection rating
Write the identification data of the machine in the specific
space on the label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorised service centre.
IMPORTANT The example of the Declaration of
Conformity is provided on the last pages of the manual.
3.4 MAIN COMPONENTS
The machine is composed of a series of main
components that have the following functions (Fig.1):
A. Engine: the driving force for the cutting
means and wheel drive (if provided).
B. Chassis: this is the casing that houses
the rotating cutting means.
C. Cutting means: the element
designed to cut the grass.
D. Rear discharge guard: it is a safety device
which prevents objects drawn up by the blade
from being hurled away from the machine.
E. Grass catcher: as well as collecting the grass
cuttings, this is also a safety element that stops
any objects drawn up by the cutting means
from being hurled away from the machine.
F. Handle: this is the operator's work station.
It is long enough to ensure the operator
remains at a safe distance from the
rotary cutting means whilst working.
G. Control lever: starts/stops the
motor and simultaneously engages/
disengages the cutting means
4. ASSEMBLY
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions to avoid
serious risks or dangers.
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly should
be done on a flat and stable surface, with enough spa-
EN - 4