Publicidad
Idiomas disponibles
Idiomas disponibles
Liquid waste may be emptied by removing the tank cover. To empty, stop the motor and remove
the plug from the wall receptacle. Remove the tank cover and deposit the liquid waste contents
in a suitable drain. After tank is empty, return the cover to its original position. To continue use,
plug the cord into the wall receptacle and turn the unit on.
With Tank Drain
Liquid waste may be emptied by removing the tank drain. To empty, turn unit off and remove
plug from wall receptacle. Remove the drain cap and deposit the liquid waste contents in a
suitable drain. After the tank is empty, return the drain cap to its original position. To continue
use, plug the cord into the wall receptacle and turn the unit on.
AUTOMATIC SUCTION SHUT-Off
The vacuum is equipped with an automatic suction shut-off that operates when picking up
liquids. As the level of the liquid rises in the tank, an internal float rises until it seats itself
against a seal at the intake of the motor, shutting off suction. When this happens, the motor will
develop a higher than normal pitch noise and the suction is drastically reduced. If this occurs,
turn unit off immediately. failure to turn unit off after float rises and shuts off suction will result
in extensive damage to the motor. To continue use, empty the liquid waste from the tank as
outlined in the previous paragraph.
NOTE: If ACCIdeNTALLy TIPPed OVeR, THe VACuum COuLd LOSe SuCTION. If THIS OCCuRS,
PLACe VAC IN uPRIGHT POSITION ANd TuRN SWITCH Off. THIS WILL ALLOW THe fLOAT TO
ReTuRN TO ITS NORmAL POSITION, ANd yOu WILL Be ABLe TO CONTINue OPeRATION.
LUBRICATION
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
Before storing your vacuum cleaner the tank should be emptied and cleaned.
The power cord can be wrapped around the cord wraps provided on the tool
holder (not standard with all models) installed on rear of unit (figure 28).
If your unit does not come with a tool holder, the cord can be wound around
the tank cover. Accessories may be stored in the tool holder (not standard
on all models) so they can be readily available. The vacuum should be
stored indoors.
TROUBLESHOOTING
Trouble
Possible Cause
Suction weakens or
Clogged filter
cleaner runs hot
Air leak
Obstruction in hose
or nozzle
misting in the
Saturated filter
exhaust air
WARNING
SHOULD BECOME DETACHED OR BROkEN, EXPOSING THE MOTOR OR ANy
OTHER ELECTRICAL COMPONENTS, OPERATION SHOULD BE DISCONTINUED
IMMEDIATELy TO AVOID PERSONAL INjURy OR fURTHER DAMAGE TO THE
VACUUM. REPAIRS SHOULD BE MADE BEfORE REUSING THE VACUUM.
THREE yEAR HOME USE WARRANTy
your Shop-Vac® vacuum cleaner is warranted for normal household use, in accordance with
the user manual, against original defects in material and workmanship for a period of three
years from date of purchase. Should this product be used for commercial or rental use, a 90
day limited warranty will apply. Shop-Vac Corporation warrants placing this vacuum cleaner in
correct operating condition, by repair or parts replacement, during the warranty period, without
charge. This warranty does not cover accessories. use of non-recommended filters and/or
accessories may void the manufacturer's warranty. Shop-Vac® assumes no responsibility
for damage or faulty performance caused by misuse, careless handling, and where repairs or
modifications have been made. do not attempt to service your vacuum beyond that described
in the user manual. Proof of purchase date is required. The warranty gives you specific legal
rights, and you may have other rights which vary from state to state or province to province.
This warranty is void outside of the united States and Canada.
Customers in the united States: for product service contact Shop-Vac Corporation, Customer
Service, at (570) 326-3557 or go to www.shopvac.com/support. Visit www.shopvac.com for
your vacuum's parts list schematic.
Customers in Canada: for product service return the complete unit, (transportation prepaid), to
the Authorized Shop-Vac® Service Centre nearest you. A complete list of Authorized Service
Centres is included with each vacuum cleaner.
Customers in mexico: for product service see paperwork that came with your unit.
STORAGE
Remedy
Brush dirt from filter. If condition continues,
change filter.
Check all fittings for tight fit (nozzles, hose, etc.)
Check that tank cover is sealed properly.
Check nozzle, hose, etc. for obstructions, and
remove if present.
Replace saturated filter with a dry filter.
– If ANy Of THE MOTOR HOUSING PARTS
28
Publicidad
