Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-800-242-4672 for assistance.
PACKING LIST
Electric Pressure Washer with Hose and Reel Assembly and
G-Clean Detergent Injector
Handle Assembly
Spray Wand
Spray Wand Storage Bracket
Bolts (2) (M6 x 40)
Washers (4)
Nuts (2)
Hose Reel Handle
Screw (M4 x 12)
Wheels (2)
Axles (2)
Hitch Pins (2)
15º Nozzle
Turbo Nozzle
G-Clean Detergent Pouch
Operator's Manual
TOOLS NEEDED
4 mm Hex Key
Screwdriver
Adjustable wrench
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
INSTALLING THE WHEELS
See Figure 4.
Locate the axles, hitch pins, washers, and wheels.
Slide the axle through the hole in the center of the wheel.
Slide a washer onto the axle before inserting into the
frame.
Lift the machine and slide the axle into the wheel mount-
ing hole in the machine base as shown.
Slide the washer on the axle, then push the hitch pin
into the hole on the end of the axle to secure the wheel
assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
Repeat with the second wheel.
ATTACHING THE HANDLE ASSEMBLY
See Figure 5.
Orient the handle assembly as shown.
Depress the button on the handle assembly and insert
into the holes on the pressure washer. Press down on
the handle assembly until the button on the handle clicks
into place.
Lower both collars on the handle and rotate clockwise
until secure.
ATTACHING THE SPRAY WAND STORAGE
BRACKET
See Figure 6.
Place the spray wand storage bracket over the holes in
the frame.
Insert a bolt through each of the holes.
Slide a washer and a nut over each bolt and securely
tighten.
Page 10 — English
Publicidad
