Black and Decker BDH2000L Manual De Instrucciones página 5

• Dispose of used batteries promptly according to the
manufacturer/supplier's instructions.
• Improper battery use may result in a fire, explosion, or
other hazard.
• Battery/tool usage by children should be supervised.
SAFETY WARNINGS AND INSTRUCTIONS: CHARGING
1 . This manual contains important safety and
operating instructions.
2 . Before using battery charger, read all instructions and
cautionary warnings on battery charger and product
using battery.

CAUTION:
use this charger only with this product. Batteries in other
products may burst causing personal injury or damage.
3 . Do not expose charger to rain or snow.
4 . Use of an attachment not recommended or sold by
BLACK+DECKER may result in a risk of fire, electric shock, or
injury to persons.
5 . To reduce risk of damage to electric plug and cord, pull by
plug rather than cord when disconnecting charger.
6 . Make sure cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
7 . An extension cord should not be used unless
absolutely necessary. Use of improper extension cord could
result in a risk of fire, electric shock or electrocution.
8 . Use only the supplied charger when charging your
tool. The use of any other charger could damage the tool or
create a hazardous condition.
9 . Use only one charger when charging.
10 . Do not attempt to open the charger. There are
no customer serviceable parts inside. Return to any
authorized BLACK+DECKER service center.
11 . DO NOT incinerate the tool or batteries even if they
are severely damaged or completely worn out. The
batteries can explode in a fire. Toxic fumes and materials
are created when lithium ion battery packs are burned.
12 . Do not charge or use battery in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery
from the charger may ignite the dust or fumes.
13 . If battery contents come into contact with the skin,
immediately wash area with mild soap and water. If
battery liquid gets into the eye, rinse water over the
open eye for three minutes or until irritation ceases.
If medical attention is needed, the battery electrolyte is
composed of a mixture of liquid organic carbonates and
lithium salts.

WARNING:
may be flammable if exposed to spark or flame.
SAVE THESE INSTRUCTIONS
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
To reduce the risk of injury,
Burn hazard. Battery liquid
...................... Class I Construction
(grounded)
...................... Class II
Construction
(double insulated)
Wh ...................... watt hours
A ......................... amperes
W ........................ watts
or AC ........... alternating current
n o ....................... no load speed
Charging the battery (Fig. B)

WARNING:
at ambient temperatures below 39°F (4°C) or above
104°F (40°C).
The charge is complete when the charging indicator
lights will turn off. The charger and the battery can be left
connected indefinitely.
• Place the appliance on the charging base as shown.
• Plug in the charger. The charging indicator LED
will illuminate.
• Leave the appliance to charge.
While charging, the charger may get warm, this is perfectly
normal and safe. The charging indicator will be lit as long
as the appliance is charging. It can remain on charge
indefinitely without damage or danger. It is not possible to
"overcharge" the battery cells with the charger provided.
Wall Mounting (Fig. C, D)
BDH2010LP
The product can be wall mounted, if desired, using the wall
mount bracket, screws and anchors supplied. To wall mount
the vac, refer to Figures C and D.
• Figure C - Mark the location of the screw holes.
• Figure D - Hang the vac on the wall by placing the
opening on the base of the vac over the hooks in the wall
mount bracket.
Use (Fig. E)
Switching on and off
• Figure E - To start, slide the On/Off switch forward (i.e.,
"O"= Off, "I" = On).
• To stop, slide the switch back.
• Return the product to the charger immediately after
use so that it will be ready and fully charged for the next
use. Ensure that the product is fully engaged with the
charger base.
Cleaning and emptying the product (Fig. F

WARNING:
Hazard: Never use the vac without its filter.
nOTE: The filter is reusable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6-9 months depending on frequency of use.
There are two methods of cleaning the bowl, a quick empty
method and a thorough clean method.
For a quick empty (Fig. F, G)
• Figure F - Press in on both nozzle release buttons on
the sides of the nozzle and remove the nozzle by pulling
straight off.
• Figure G - Empty the dust from the bowl.
• For a more thorough cleaning, remove bowl as described
in Figures H, I, and J.
English
...................... earthing terminal
..................... safety alert symbol
.../min or rpm .. revolutions or
reciprocation per
minute
Do not charge the battery
J)
–
Projectile/Respiratory
5