Gaggia La Precisa EL1 Uso Y Mantenimiento página 62

English
5.2 Electrical connection
Before proceeding
electrical connection,make
sure that the voltage rating
corresponds
indicated on the CE plate
and on the connection
plate on the power supply
cable. Check to ensure that
the electrical supply line is
able to
machine load (see chapter
"Technical features").
Connect to an earthing socket which complies with
current legislation.
Check that the power
supply cable is efficient and
that it complies
national and
safety standards.
The user must undertake to
power the
protecting the power line
using a suitable safety switch
(cut-out) that complies with
the legislation in force in the
country itself.
62
with
with that
support the
with
European
machine
Connect the power cable (E) to the electric line using a
plug, or in the case of fixed installation, using a multi-polar
switch (D) for mains separation, with a contact distance of
at least 3 mm.
Please refer to the technical
manual for voltage change.
The yellow-green coloured
cable MUST be connected
to the room's earthing
system.
Depending
regulations in force in the
Country where the machine
is being used, the cable
connecting to the power
supply has to be pre-set or
equipped with an all-pole
switch (with a minimum
contact opening of 3 mm),
or with a plug complying
with the same regulations.
It is recommended the
installation of a residual
current device (RCD) with
a rated residual current not
exceeding 30 mA.
on the