Tool Up SPARK MIG 110 Manual Del Usuario página 15

TROUBLESHOOTING
SYMPTOMS
The welding wire speed is not
constant.
The wire-feeder motor doesn't
operate.
Bad wire feeding.
No welding current
The wire jams (after the rollers).
The welding bead is porous.
The arc produces a lot of sparks
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
SPARK MIG 110
POSSIBLE CAUSES
Debris is blocking up the opening.
The wire skids in the rollers
Reel or roller brake too tight
Electrical supply problem.
Covering wire guide dirty or damaged Clean or replace
Reel brake too tight
Bad connection to the main supply
Bad earth connection.
Guide wire sheath crushed.
Wire jammed in the torch
No capillary tube.
Wire speed too fast
Nozzle dirty
Poor quality wire.
Work piece in bad condition. (rust,
etc...)
Arc voltage too low or too high.
Bad earth connection.
REMEDIES
Clean out the contact tip or change it
and replace the anti-adherence
product.
Ref.041806
Check the roller pressure or replace
it.
- Wire diameter incompatible with
roller
- Covering Wire guide in the torch
incompatible
Adjust the brake and rollers.
Check the power switch is in the "On"
position.
Release the brake
Check the mains connection and
ensure the supply is 230V (1PH)
power socket.
Check the earth cable (connection
and clamp condition).
Check the sheath and torch body.
Clean or replace.
Check the presence of capillary tube.
Reduce the wire speed.
Clean or replace nozzle.
Use suitable wire for no gas welding.
Clean the metal before welding.
See welding settings.
Adjust the earth cable for a better
connection.
EN
15