imp. JC 744 B-R rev 00:imp. JC 474 B-R
5-08-2009
20:23
Pagina
JC-474 B/R
G
PROFESSIONAL HAIRDRYER
INSTRUCTION MANUAL
Congratulations on having purchased the JOYCARE Professional hairdryer.
Negative ions are naturally generated from Tourmaline ceramic, they purify your
hair removing any unattractive "frizzy effect" . The Tourmaline ceramic technology
makes it possible to emit heat delicately and uniformly in order to make your hair
softer, moisturized and shiny.
GENERAL SAFETY INSTRUCTIONS
Before using this product, please read carefully this instruction manual.
It is advisable to save these instructions for a future use.
Before connecting the appliance, check the voltage indicated on the appliance
corresponds to the local mains voltage.
Always unplug the appliance:
- When it is not in use
- When you attach accessories
- Before cleaning it
- In case of troubles
Unplug the appliance, only after having switched it off. Never try to unplug the
product pulling it from the cable or from the product itself.
Never wind the cord around the main body.
In order to protect children from risks of electrical shocks, never leave the
appliance unattended when it is plugged in. Always store it out of their reach.
Check regularly both the product and the cable: in case you find some damages,
the product must not be used.
Do not try to repair the product by yourself but always address to authorised centres.
Keep the device and the cable away from heat, direct sunlight, moisture, sharp
objects and similar ones.
Never leave the product unattended if switched on! Switch it off and unplug it
when you do not use it, even if it is only for a while!
Use original accessories only.
When hairdryer is working, its air inlets and outlets must never be closed.
The product must not be absolutely plunged in water or other liquids or coming in
contact with them! Never use the appliance with wet or moist hands.
In case the appliance becomes moist or wet, please unplug it immediately from the
socket. DO NOT TRY TO REACH THE PRODUCT INTO WATER!
Use the device only for its intended purpose.
Additional protection is offered by the installation of a fault current protective
device with a rated breaking current of not more than 30 mA in the domestic
electrical system. Ask a professional electrician for advice.
7