Publicidad
Idiomas disponibles
Idiomas disponibles
6
Información Técnica:
No instalar en lugares donde pueda haber
condensación, penetración o salpicaduras
de agua.
7
Consejos de seguridad y uso:
8
Gestión de residuos de envases y de productos:
MATERIAL
DEPOSITAR EN
CONTENEDOR
PLÁSTICO
AMARILLO
CONTENEDOR
PAPEL Y
AZUL
CARTÓN
NOTA: El color de los contenedores puede variar en función del pais donde se aplique. Consulte la normativa local
al respecto.
Instructions for use and safety
1
General view:
Normative: -Follow these instructions to comply with the R.D. 842/2002.
2
- Installation, service and maintenance of the electrical equipment may be carried out by an authorized person only.
Description:-- Dimensions = 81x82; - Supply voltage = 230V ~ 50Hz; - Power = 2W; - Lumen = 110; * Reserve time = 3h (after
3
power cut).; - * Charge time = 24h. Mechanism to embed in universal box.- 4 interchangeable windows.- Screw connection.
* Only for pilots with reserve = ERP90CR3; ERP90CR3U.
4
Assembly instructions: 1- Disassemble the frame by pressing out of the chassis firmly. 2- Make sure that the cables have no
tension. 3- Carry out the electrical installation as indicated in the following section (5 ELECTRICAL CONNECTION). 4-Fix the
chassis to the embedded box: 4A- Using the box screws (figures 4A). 4B- When the box does not have a screw system, it must
be fixed using the internal claws of the chassis. Access the claw screws and tighten them until the chassis is fixed on the box
(figure 4B). 5- Choose the color of the window and replace it if desired, as indicated in the attached diagrams (5A and 5B). 6-
Assemble the Cover + Window on the frame; then center the legs with the frame and press until it stops.
5
Electric connection
Installation only refs. erp90cr3 and erp90cr3u (reserved pilots): 1.When connecting to the mains, you must place the switch in
the ON position. The internal battery will begin to charge. 2. The light will remain on while it is connected to the mains and there
is voltage, and it will turn on when the supply fails for any reason or is disconnected. 3.When you are going to disconnect the
pilot for transport or storage, you must place the switch in the "OFF" position. This will prevent the pilot from turning on
unnecessarily and discharging the internal battery.- Reserve time = 3h (after power failure ).- Charge time = 24h.
6
Technical information: Do not install in places where there may be condensation,
penetration or splashes of water.
7
Safety and usage tips
8
Management of packaging and product waste: PACKAGING WASTE; MATERIAL; PLASTIC; PAPER AND PAPERBOARD;
DEPOSIT IN; YELLOW CONTAINER; BLUE CONTAINER; LOGO IN SPAIN (NOTE); INTERNATIONAL LOGO (NOTE); LOGO IN
FRANCE (NOTE); PRODUCT WASTE; WASTE; WEEE; DEPOSIT IN; SELLING POINT or LOCAL RECYCLING CENTER; LOGO
(NOTE).NOTE: The color of the containers may vary depending on the country where it is applied. Check local regulations on this.
RESIDUOS DE ENVASE
LOGOTIPO
LOGOTIPO EN
ESPAÑA
INTERNACIONAL
GWT 850ºC
RESIDUOS DE PRODUCTOS
LOGOTIPO EN
RESIDUOS
FRANCIA
RAEE
window; top; frame, chassis.
-3-
DEPOSITAR EN
LOGOTIPO
PUNTO DE
VENTA O
ECOPARQUE
MUNICIPAL
ENGLISH
Halogen Free
Publicidad
