Urmet 2VOICE 1760/15 Manual De Uso página 19

1 VOICE COMMANDS
The video door phone allows the activation of some of the video door phone functions through voice
commands. By saying certain phrases it is possible, for example, to answer a call or open the pedestrian
door without pressing the keys on the display.
ATTENTION! To use the voice commands, on the Master video door phone, it is necessary that:
— the video door phone is configured in the Local power supply mode;
— the call forwarding function is configured on the video door phone.
To use the voice commands on a Slave video door phone, if any, it is necessary that the WiFi is configured
on the device.
Enable the function in the configuration menu of the video door phone (refer to the chapter "Enabling
and configuring voice commands").
To enable voice commands, pass your hand once in front of the video door phone IR sensor.
<1 s
BEEP
The video door phone emits a "BEEP" as confirmation signal and the display shows the following pop up:
After the beep you can say the voice command.
Below are the instructions for using the voice commands to activate the functions.
19
DS1760-067