Publicidad
Idiomas disponibles
Idiomas disponibles
RESET
1
CONNECTION
IMPORTANT: it is recommended to use quality HDMI cables, of the strictly necessary length and avoiding
large lengths so that there is no noticeable loss in the signal. High quality Cat 6 cables with FTP/SFTP
shielding are recommended. Cables should have shielded connectors with the cable shielding connected
to the connector shield. This improves the reliability of the HDMI extenders, avoiding ground loops caused
by interconnecting devices (player/receiver and TV) with different ground reference which may cause loss
or break-up of the picture.
- Make connections with all equipment turned off.
- Connect the HDMI signal source to the INPUT of the transmitter.
- Connect OUTPUTs to monitors, TVs and/or projectors using HDMI cable.
- Connect the data cable between transmitter and receiver. Up to 70 m for 4K@60Hz and FULL HD 1080p
1
resolution with Cat 6 cable.
- Optional - Connect the remote control extenders by pointing the TX at the IR receiver of your player and
the RX at the place where you want to control the player from your remote control.
- Connect the power and turn on the equipment. First the sources, then the extension and fi nally the
equipment connected to the outputs.
- If you have any problems with the signal display, reset both devices by pressing the RESET button on
both devices.
VIDEO RECEIVER
INSTALLATION
It is possible to fi x both devices to a fl at surface with the help of the 4 included mounting brackets as shown
below.
1
SIGNAL
2
3
2
3
HDMI
7941XT-UHD
TRANSMITTER
4
4
CAT 6
CABLE
7941XT-UHD
RECEIVER
2
- 3 -
5
6
5
6
HDMI
TV
EN
7
Publicidad
