IPC ML CMP D1310P M Manual De Instrucciones página 21

CLASSIFICATION OF RISKS:
!
Danger
Identifies an imminent risk which could lead to serious or fatal
injury.
!
Warning
Identifies a risk situation which could lead to serious injury.
Information
Identifies a risk situation which could lead to minor injury or
damage to things.
!
Warning
You must read this manual before installing, starting up and
using the high pressure washer.
This manual is an integral part of the product.
Read the warnings and instructions contained in the manual
carefully as they provide important information on USER SA-
FETY and MAINTENANCE, paying particular attention to the
general safety regulations.
KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE
REFERENCE.
!
Warning
Those operating and servicing the high pressure washer must
be aware of the contents of this manual.
CLASSIFICATION
The user must respect the conditions for using a high pressure
washer specified in current regulations and standards. In parti-
cular you must respect the classification below.
The high pressure washer is classified as a Class I appliance
for protection against electric shock.
The high pressure washer is regulated in the factory and all
safety devices are sealed. They must not be adjusted.
The high pressure washer must always be used on firm flat
ground. It must never be moved while in operation or when
connected to the mains electricity supply.
The high pressure washer is considered as a permanently
installed appliance.
Failure to respect this classification may be a cause of dan-
ger.
The high pressure washer must not be used in the presence
of corrosive or potentially explosive atmospheres (vapours or
gases).
PREFACE
English
GENERAL SAFETY RULES FOR
THE USE OF HIGH PRESSURE
Warning
!
- The high pressure washer must be elec-
trically connected by a qualified electrician
able to operate in respect of current regula-
tions and standards (in compliance with the
provisions of IEC 60364-1) and in accordan-
ce with the Manufacturer's instructions.
Incorrect connection may cause damage to
people, animals or things and absolves the
Manufacturer of all liability.
- High pressure washers with a power rating
of less than 3 kW are fitted with a plug for
connection to the mains electricity supply.
- Make sure the power rating of the electrical
installation and sockets is adequate for the
maximum power of the appliance as indica-
ted on the rating plate (kW).
If in doubt, contact a qualified electrician.
If the socket and the plug on the appliance
are incompatible, have the socket replaced
with a suitable type by a qualified electrician.
Before connecting the high pressure washer,
make sure the specification on the rating
plate is compatible with that of the mains
electricity supply.
- Do not use extensions to power the high
pressure washer.
If you use an extension, the plug and socket
must be watertight. Unsuitable extensions
may be dangerous.
- The electrical safety of the high pressure
washer is guaranteed only when it is cor-
rectly connected to an efficient earth system
as specified by current electrical safety stan-
dards and regulations (in compliance with
the provisions of IEC 60364-1).
- 17 -
CLEANERS