Publicidad
Idiomas disponibles
Idiomas disponibles
next to the barbecue and safely away from any source of heat. Should you need to install or change the
gas bottle, confirm that the barbecue is switched off, and that there are no sources of ignition (cigarettes,
open flame, sparks, etc.) near before proceeding.
Fixing a Regulator to the Gas Bottle
Confirm all barbecue control knobs are in the off position. Connect the regulator to the gas bottle
according to your regulator and bottle dealer's instructions.
Leak Testing
(Always perform a leak test in a well-ventilated area)
position. Turn the gas on / open the gas control valve on the gas bottle or regulator. Check for leaks by
brushing a solution of ½ water and ½ liquid detergent / soap over all the gas system joints, including gas
bottle valve connections, hose connections, and regulator connections. NEVER USE AN OPEN FLAME
to test for leaks at any time. If bubbles form over any of the joints there is a leak. Turn off the gas supply
at the gas bottle. Retighten all joints. Repeat test. If bubbles form again do not use the barbecue and
contact your local distributor for assistance. Always wipe the mixed solution (½ water and ½ liquid
detergent / soap) from all joints and connections after leak testing.
OPERATION
Warning
Before proceeding, make certain that you understand the IMPORTANT INFORMATION section of this
manual.
Your barbecue is not designed to be used with more than 50% of the cooking area as a solid plate —this
includes baking dishes. Full coverage will cause excessive build-up of heat and damage the barbecue.
This is not covered by warranty.
Preparation Before Cooking
To prevent foods from sticking to the cooking surface, please use a long handled brush to apply a light
coat of cooking or vegetable oil before each barbecuing session. (Note: When cooking for the first time,
paint colours may change slightly as a result. This is normal and should be expected.) During use, the
protective coating may come off the cooking surface. This is normal an is not harmful. Line the drip pan
with aluminum foil. This will make cleanup easy.
Lighting the Main Burner
1.
The lid must be open before lighting.
2.
Set all knobs to "Off".
3.
Open the gas bottle valve according to operating instruction.
Push in and turn the middle burner knob anti-clockwise until it reaches the ignition sign and a click sound
is heard.
4.
Then push in and turn the left or the right knob same way until the burner is lit.
5.
If the burner does not light, turn all knobs "Off" and repeat Step 4 and 5 after 5minutes.
Confirm all control knobs are in the off
21
Publicidad
