Naterial ZEFIR AW2 RM 3.95x3 Instrucciones De Montaje página 90

FR
Swallowed batteries are lethal. Keep batteries out of reach of children and pets. Immediately
ask for medical assistance if a battery is swallowed.
ES
Remove exhausted batteries from the remote control. Remove the batteries from the remote
PT
control, if you will not use it for an extended period of time.
I T
EL
PL
The motor will automatically go into overheat-protection mode after two
UA
RO
NL
EN
7. ADJUSTMENT WHEN CHANGING THE REMOTE
CONTROL
electric cords of motor to the power interface (Or with electric cord of motor plugged in a power
Step 2: Take out the controller and keep the battery in place, the inductor light will be on. If not in
place, the inductor light will not be on. No need to cover the battery lid before well-coding.
Step 3: Keep ear close to the head of motor and then turn on the power under a quite environment
a clear but small and short sound «Di». This shows it work well. If without that sound, you need to
check the cord-connecting or the power.
Step 4: 1. Find «P2» button in the battery slot firstly 2. Keep ear near to the head of motor under
quite environment and then press «P2» button 2 times successively. At the same time you will hear
«Di-Di», small and more shorter.
Step 5: After the sound of «Di-Di», press «Open» button for 3 seconds and then release, you will
hear successive short sound of «Di-Di---» at the same time when you press the «open» button. That
X1 Changing batteries
Overheat protection:
consecutive extending (down) and retracting (up) operations
2014/53/EU-2014/30/EU-2014/35/EU-2006/42/EC
Conform to:
90