DeWalt DCR006 Manual De Instrucciones página 4

Altavoz inalámbrico de bluetooth de 12v/20v máx
Ocultar thumbs Ver también para DCR006:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

has been exposed to rain or moisture, does not operate
normally, or has been dropped.
14. Apparatus shall not be exposed to dripping or splashing and no
objects filled with liquids, such as vases, shall be placed on the
apparatus
The lightning flash with arrow head within a triangle is intended
to tell the user that parts inside the product are a risk of electric
shock to persons.
The exclamation point within a triangle is intended to tell the
user that important operating and servicing instructions are in
the papers with the appliance.
Additional Safety Rules for Bluetooth
Speaker
• DO NOT splash or immerse in water or other liquids.
• Please note that changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
®
NOTE: The Bluetooth
trademarks owned by the Bluetooth
such marks by D
WALT is under license. Other trademarks and
E
trade names are those of their respective owners.
• This Class B digital apparatus complies with Canadian ICES-003.
• This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
Page dimensions: 8.5 x 5.5 inches
®
word mark and logos are registered
®
, SIG, Inc. and any use of
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and speaker.
– Connect the equipment into an outlet on a circuit different from
that to which the speaker is connected.
– Consult the dealer or an experienced radio/TV technician for
help.
• The label on your tool may include the following symbols. The
nameplate label is located on bottom of unit. The symbols and
their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min .......... per minute
BPM ............. beats per minute
2
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating
........................or direct
current
n o ....................no load
speed
n ......................rated

Publicidad

Tabla de contenido
loading

Tabla de contenido