Keba b-serie Manual página 16

Programming in a slave card (adding a user card to the whitelist)
To program in a slave card, it is not permitted for any charging session to be active and in addition it is not
permitted for any vehicle to be plugged in to the charging station. The authorization function of the charging
station must be activated. The LED bar display on the charging station flashes blue in idle condition.
Hold the RFID master card in front of the RFID reader and wait for the signal tone.
Then hold the new slave card for the programming process in front of the RFID reader within 3 seconds.
A supported card model is indicated by a rising tone sequence.
Confirm the programming process by holding up the master card again within 3 seconds. The procedure
is concluded by a further rising tone sequence. The charging station will then be in non-authorized idle
condition and flashes blue.
Starting a charging process with activated RFID authorization
With activated authorization of the charging station, the bar display flashes blue in idle condition.
Plug the vehicle into the charging station.
Hold an RFID card from the whitelist in front of the RFID reader.
A valid card from the whitelist is confirmed with a signal tone and a charging session can be started from
the vehicle.
Note
● Pre-authorization:
If the charging station is authorized without a vehicle plugged in, a vehicle can be plugged in
for 60 seconds and this will start a charging session. If this time interval elapses without a vehi-
cle being plugged in, the charging station changes back to non-authorized idle condition.
● Enable input [X1]:
Special device versions provide the additional option of making the authorization of a charging
session dependent on the activation of an enabling input. If you have activated this function on
the DIP switch, enabling a charging session will require a correct signal on the enabling input
in addition. Further information on this can be found in the "Installation manual".
16/112 - en
Authorization functions