Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
your hands by wearing heavy gloves
or wrapping the blade with rags or
other materials when performing any
maintenance on the edger blade.
To remove the blade
1. Stop the motor and remove the
battery pack.
2. Lay the edger on its back so that the
blade is facing upwards.
3. Wear protective gloves. Use needle
nose pliers (not included) to remove
the cotter pin from the motor shaft
(Fig. 12).
4. Rotate the blade to align the slot in
the flange with the hole in the gear
case (Fig. 12).
5. Insert a steel rod, into the aligned
holes to act as a stabilizer. Use the
multi-function wrench provided to
loosen the nut CLOCKWISE (Fig. 13).
6. Remove the nut, outer flange, blade,
and the inner flange from the motor
shaft (Fig. 14). Check and replace
them if they are worn.
56V LITHIUM-ION COMMERCIAL 8" CURVED SHAFT EDGER — EDX2000-C/EDX2000-C-FC
Always protect
12
Cotter Pin
Inner Flange
Gear Case
Aligned Shaft-locking Holes
13
Stabilizer
14
Motor Shaft
Multi-function
Wrench Provided
Slot
Inner Flange
Blade
Outer Flange
Nut
Cotter Pin
25
Publicidad
