Epson TM-H6000II Manual Del Usuario página 21

Note:
When cleaning the scanner glass, do not use any liquid, such as detergent,
benzine, or water.
Liquids can reach the back of the scanner glass and cause it to become dirty. If
the scanner glass has foreign matter that is hard to remove, such as oil or
grease, you can wet a cloth a little with alcohol and wipe the scanner glass,
but never put any liquid directly on the scanner glass.
Card Image Scanning
1. Wait until the ID light flashes. Then insert the card face up into the
card entrance as far as it will go. See illustration M.
2. The printer will detect the card and start drawing it in. When the
printer starts drawing it in, let go of the card immediately. When the
printer ejects the card and the ID LED starts flashing again, remove
the card by pulling it straight out; do not pull it at an angle.
Notes On Using the
❏ Be sure to insert the card with the face to be scanned up.
❏ Be sure the card is flat without excessive curvature, cracks, folds,
or embossing.
❏ When using an IC card, be sure not to touch terminals when
holding the card.
❏ Because the card sensor uses a photo sensor, be sure not to use a
card that has holes at the sensor position or is translucent. See
illustration N for the limited area for the holes and translucency.
❏ Appropriate image data quality might not be acquired in the
following conditions:
• Excessive damage such as curvature, cracking, or folding of
the card.
• Embossed cards.
• When the image scanner part is exposed to excessive light
such as sunlight, a spotlight, or fluorescent lamp.
• When the scanner glass has been damaged by foreign matter
such as sand.
Card Image Scanner
TM-H6000II with Image Scanner User's Manual 11
English