Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Float in raised position
IMPORTANT: To reduce the risk of damage to
the vacuum, do not run motor with float in
raised position.
NOTICE:
IF ACCIDENTALLY TIPPED OVER, THE VACUUM
COULD CLOSED SUCTION. IF THIS OCCURS,
PLACE VACUUM IN UPRIGHT POSITION AND
TURN SWITCH OFF. THIS WILL ALLOW THE FLOAT
TO RETURN TO ITS NORMAL POSITION, AND YOU
WILL BE ABLE TO CONTINUE OPERATION.
EMPTYING THE TANK
WARNING: To reduce the risk of injury
from accidental starting, unplug power cord
before emptying the dust tank.
1. Remove the power head assembly of the
wet/dry vacuum by pulling outward on the
lid clips located on each side of the vacuum.
Lift off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
3. Liquids may be emptied through the tank
drain. To empty, turn the Unit off and
remove the plug from the wall outlet.
Remove the drain cap and deposit the
liquid waste contents in a suitable drain.
After tank is empty, return the drain cap
to its original position. To continue use,
plug the cord into the wall outlet and
turn the unit on.
BLOWING OPERATION
WARNING: Always wear safety eyewear
complying with ANSI Z87.1 (or in Canada
CSA Z94.3) when using as a blower.
WARNING: To avoid injury to bystanders,
keep them clear of blowing debris.
CAUTION: Wear a dust mask if blowing
creates dust which might be inhaled.
CAUTION: To reduce the risk of hearing
loss, wear ear protectors when using the vacuum
/blower for extended hours or when using it in
a noisy area.
The vacuum contains a blowing feature. It has
the capability to blow sawdust and other debris.
It can be used to blow dust and debris out of
garages or off patios and driveways. Follow the
steps below to use the vacuum as a blower.
1. Locate blowing port on the vacuum.
2. Insert one end of the 1-7/8 in. x 6 ft.
(4.8 cm x 1.8 m) hose into the blowing port.
3. Turn vacuum "ON".
FILTER REPLACEMENT
WARNING: To reduce the risk of injury
from accidental starting, unplug power cord
before changing or cleaning filter. The filter
should be cleaned frequently to maintain peak
vacuum performance.
WARNING: Do not remove filter cage and
float. The float prevents water from entering the
impeller and damaging the motor. The cage
prevents fingers from touching the moving impeller.
CAUTION: To avoid damage to the impeller
and motor, always reinstall the reusable filter
before using the vacuum for dry pickups and
always reinstall the foam filter before using the
vacuum for dry pickups and wet pickups.
6
Publicidad
