CAUTION: After cleaning, check the filter
for tears or small holes. Do not use a filter with
holes or tears in it. Even a small hole can cause
dust to come out of the vacuum. Replace it
immediately.
CAUTION: Clean the filter in an open area.
CLEANING
To keep the wet/dry vacuum looking its best, use
a cloth dampened only with water and mild soap
to clean its surface.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with a cloth dampened
only with water and mild soap.
3. Wipe with dry cloth.
STORAGE
Before storing the vacuum, the dust tank should
be emptied and cleaned. The cord should be
wrapped and hung on the unit and the
accessories should be kept in the accessory
holder. The vacuum should be stored indoors.
TROUBLESHOOTING
Minor problems often can be fixed without calling
customer service.
PROBLEM
POSSIBLE CAUSE CORRECTIVE ACTION
Vacuum does
No electricity
not run
Loss of suction,
1. Full tank
wet pick-up
2. Clogged hose
3. Clogged filter
Loss of suction,
1. Full tank
dry pick-up
2. Clogged hose
3. Clogged filter
Make sure electrical
outlet has voltage (A
qualified electrician may
need to be contacted)
1. Drain and clean tank
2. Remove hose and clean
debris
3. Clean or replace filter
1. Drain and clean tank
2. Remove hose and clean
debris
3. Clean or replace filter
7
ENGLISH