Publicidad
Idiomas disponibles
Idiomas disponibles
WHEEL GEARS/PAWL SERVICE
IMPORTANT: Do not remove both wheels at the same time to
avoid mixing parts. (The R.H. and L.H. ratchet gears are not
interchangeable.) Make notes on the position of washers and
snap rings during disassembly.
1.
Remove only one wheel from the sweeper.
2.
Remove the retaining rings and washers which hold the
ratchet gear onto the brush shaft.
3.
Remove the gear by sliding it off the brush shaft. (Look for
the drive pin, which may fall out of the brush shaft when the
ratchet gear is removed.
4.
To reassemble, insert the drive pin through the hole near the
end of the brush shaft. Make sure the pin slides back and
forth easily in the shaft.
5.
Lightly grease the shaft and fill the ratchet gear with grease.
Assemble the ratchet gear back onto the shaft.
6.
Lightly grease the axle and the gear teeth on the wheel
and then reassemble the wheel. The brushes should rotate
only during forward movement. If the brushes rotate by both
forward and reverse movement, the drive pin is jamming in
the ratchet gear. Disassemble, clean and lubricate the drive
pin and ratchet gear and then reassemble wheel.
7 .
Remove opposite wheel and repeat steps 1-6 for that wheel.
13
27
25, 26
BRUSH REPLACEMENT
1.
Remove the hopper bag from lawnsweeper.
2.
Brush replacement should be done one brush at a time.
3.
Tip the sweeper forward on housing for ease of brush
replacement. Do not remove hex bolt from double brush
retainers through brush shaft.
4.
Loosen hex bolts and hex lock nuts from single brush
retainers. See figure 14. Slide brush out of retainers, making
sure not to overlap bristles.
5.
Install new brush, making sure over-lap bristles are
positioned the same as before and as shown in figure 14.
14
RIGHT END VIEW
OF BRUSH
DOUBLE
BRUSH
RETAINER
OVERLAP
BRISTLES
6
BRUSH
ROTATION
OVERLAP
BRISTLES
SINGLE BRUSH
RETAINER
BRUSH
SHAFT
SINGLE BRUSH
RETAINER
BRUSH
ROTATION
Publicidad
