Cooper Lighting Solutions HALO ARFL15DBZ Instrucciones página 4

IL51880222
4. ATTACHING THE HANDS-FREE INSTALL WIRE
FOR INSTALLATION WITH WALL/EAVE MOUNT BASE PLATE ONLY
Take the round "ball" head of the hands-free wire (F), attached to the back of the junction box
•
mounting plate (D), and place it behind the bottom-center"notch"of the mounting plate (D).
Ensure the fixture can now hang freely to allow for hands-free connection of the electrical wires.
•
NOTICE: After electrical connections are made un-hook the hands-free wire (F) and then
mount the fixture onto the mounting plate (D)
5. MAKING THE ELECTRICAL CONNECTIONS
IF NECESSARY, STRIP 3/8 IN. OF INSULATION FROM THE JUNCTION BOX OR FIXTURE (A) WIRES
Wiring Instructions
Connect the fixture black wire to the supply black wire ((+)line),and fixture white wire to the supply white wire ((-) common) by twisting the
•
exposed wires together and using the wire nuts (BB).
Connect the supply green ground wire to the green fixture ground wire by twisting the exposed wires together and using the wire nuts (BB)
•
IMPORTANT: Hold stripped ends near each other and align any frayed strands (do not twist wires). Push the wires into wire nut (BB) and use
your fingers to twist the wire nut clockwise until tight. Check for tightness by pulling wires.
5
3/8 in.
Wall Mount
6. SECURING THE FIXTURE AND WIRING
Wall/Eave Mount
Once the fixture is wired,place the fixture on the mounting plate (D) and use the hex bolts (E) to tighten the fixture on the plate (D) by using the
•
allen key (CC).
Ensure no wires are pinched between the mounting plate cover (D) and mounting surface.
•
NOTICE: Make sure the light fixture head is in the desired left/right direction before
securing the wall mount plate (D) to the junction box plate
7. CAULKING AROUND THE LIGHT FIXTURE
Caulk around the mounting plate (D) and surface with
•
silicone sealant (not included).
If applicable, plug all unused holes and seal threads with silicone.
•
8. ADJUSTING THE LIGHT HEAD AND TESTING
To adjust the Up/Down direction of the fixture head, loosen the knob screw G
•
on the swivel portion of the knuckle (B).Adjust the fixture to a suitable
orientation with the knuckle, and then tighten the screw again.If applicable,
plug all unused holes and seal threads with silicone.
Restore power to the breaker and light switch and test if the
•
light turns ON.
IMPORTANT: Only loosen the knuckle screw knob enough to rotate the fixture head.
Do not fully remove the knuckle screw knob.
4
D
BB
Swivel Knuckle
Flood Mount
Black
(+) Line
White
(-) Common
Green
Ground
BB
LED Slim Flood & Wall light Instructions
4
Wall/Eave Mount
6
Lighting
Fixture
7
D
Wall Mount
8
B
A
G
ENGLISH
D
F
D
CC
E
B
Swivel Knuckle
Flood Mount
A
B
G
www.cooperlighting.com