Cooper Lighting Solutions HALO ARFL15DBZ Instrucciones página 5

ENGLISH
OPERATION
THIS FIXTURE IS EQUIPPED WITH A REMOTE CONTROL TO CONFIGURE THE LIGHT COLOR
TEMPERATURE SETTING AND TO TURN THE PHOTOCELL ON OR OFF.
SELECTING LIGHT COLOR TEMPERATURE SETTING
Ensure the RC power ON mode and choose different light color on RC to get your desired light color.
•
CCT Setting
2700K
SELECTING DUSK-TO-DAWN OR SWITCH-CONTROLLED MODE
Option 1: Dusk-to-Dawn Operation
Dusk-to-dawn operation enables the light fixture to automatically turn ON when dark outside and turn OFF when the
sun rises, thus saving you energy.
Ensure the RC power ON and photo-cell switch ON mode at all times to enable dusk-to dawn functionality to
•
operate automatically.
Photocell
Setting
P/ON
Option 2: Switch-Activated
Switch-controlled operation enables the light fixture to turn ON and OFF by flipping a standard light
switch.
Once the fixture is installed,turn the power back on from the circuit breaker and switch.
•
Ensure the RC Power ON and Photocell switch OFF mode to enable Switch-Activated functionality
•
Flip the switch ON and OFF to ensure light functions properly.
•
NOTE: This fixture is not dimmable.
Do not use a dimming switch.
CARE AND CLEANING
Shut off the main power supply before cleaning the product. To prolong the original appearance, clean the light fixture with clean water and a
•
soft, damp cloth only.
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints, solvents or any other chemicals on this light fixture. They
•
could cause a premature deterioration of the finish and may void the warranty.
Do not spray the light fixture with a hose or power washer.
•
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
The light does There is no power to
not turn ON. the fixture
The fixture senses
daylight
The light cycles The photocell light
ON and OFF sensor is sensing
continuously. reflected light
The light flickers. The light fixture wired
through a dimmer
switch
The light stays The light sensor is in a
ON. shaded area.
The light sensor is
faulty.
NOTE: Photocell has a short delay in order to reduce its sensitivity to sudden light changes. When testing, shine a light and cover the photocell for a
short time to check if the fixture functions properly.
LED Slim Flood & Wall light Instructions
3000K 3500K 4000K 5000K
NOTE: If photocell is located in an area under heavy
shade the photocell may not detect enough light and may
turn the light fixture ON.
P/OFF
NOTE: Operating fixture in constant ON state during daytime could
reduce fixture lifespan and may not be qualify for a warranty replacement.
SOLUTION
• Check if circuit breaker is tripped.
• Confirm wall switch is ON. Verify wiring to the fixture is correct (turn power OFF to fixture beforehand).
Cover the photocell. wait a short time until the fixture turns ON.
• Relocate the light fixture to a location where there is no reflected light.
• OR place the optional photocell cover over the photocell light sensor and use the wall switch to turn the light ON
and OFF.
Do not use a dimmer switch to control the light fixture. Replace the dimmer with a standard ON/OFF switch.
• Shine a flashlight into the light sensor and wait a minute. If the light turns OFF, the fixture should be moved to a
location with enough light in the daylight hours for the light sensor to work.
• OR place the optional opaque cover over the photocell light sensor and use the wall switch to turn the light ON
and OFF.
If the light does not turn OFF when a flashlight is shined on the light sensor for a minute, then the sensor may be
faulty. Please contact customer service.
www.cooperlighting.com
IL51880222
Color
temperature
Manual Power on
selectable
and power off
buttons
Photocell ON Photocell OFF
5