Publicidad
Idiomas disponibles
Idiomas disponibles
Sunea 40 RTS DC
1] Disconnect the drive from the battery or the external power supply for 2 s.
2] Reconnect the drive for 5 to 15 s.
3] Disconnect the drive for 2 s.
4] Reconnect the drive: the motorised product moves for a few seconds. (If the
motorised product is in the upper or lower end limit, it makes a brief up and
down movement).
5] Press the PROG button on the new control point until the motorised product
moves up and down:
g The new control point is programmed and all the other control points are
deleted.
2.4.4.Restoring the original configuration
NOTICE
This reset deletes all control points, sensors, end limit settings and resets the drive's favourite position (my).
1] Position the motorised product at the mid-height position (if possible).
2] Disconnect the drive from the battery or the external power supply for 2 s.
3] Reconnect the drive for 10 to 15 s.
4] Disconnect the drive for 2 s.
5] Reconnect the drive: the motorised product moves for a few seconds. (If the
motorised product is in the upper or lower end limit, it makes a brief up and
down movement).
6] Press the PROG button on the Somfy local control point for≈ 7 s, until the
motorised product moves up and down twice.
g The drive is reset to the original configuration.
Repeat the commissioning procedure (Refer to Commissioning [} 9]).
3.USE AND MAINTENANCE
NOTICE
This drive does not require any maintenance operations.
3.1.Up and Down buttons
Briefly press the Up or Down button to raise or lower the motorised product fully.
3.2.Stop function
The motorised product is moving.
▪ Briefly press my:
◦ The motorised product stops.
©
Copyright
2023 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
OFF
ON
2 s
3]
4]
OFF
ON
2 s
5]
0.5 s
PROG.
1]
2]
OFF
3]
4]
ON
OFF
10 s
5]
6]
ON
7 s
PROG.
EN
10 s
2 s
2 s
my
15
Publicidad
