Publicidad
Idiomas disponibles
Idiomas disponibles
pages.
3. PRODUCT ASSEMBLY
The device can be installed either on the floor or on the wall (feet and mounting brac-
kets included).
Note
- Never install the appliance directly under a wall socket.
- Never install the appliance in a place or position where it can be reached from the
bath or shower.
- The heater operates on natural-air convection. For optimum performance and even
heat distribution, when installing the heater on the wall, the bottom should be at least
20 cm from the floor, 20 cm clearance to the sides, 50 cm clearance on the top, and 20
cm from any walls or objects (furniture, curtains, etc.). Fig. 3-4
Wall assembly
- Choose a suitable spot on the wall; it should be steady and level. Check that there is a
power socket nearby.
- The distances marked "a" and "e" will depend on the heater's model. Fig. 5-6
Table 1. Reference distances by model for installation:
Model
EVVO C4
EVVO C6
EVVO C8
EVVO C10
EVVO C12
1. Always follow the above safety measures (Fig. 5-6). Make 2 marks on the wall accor-
ding to the "e" measurement indicated in Table 1 and at 695 mm from the floor. Fig.
7
2. Drill 2 holes of 10-mm diameter with a minimum depth of 60 mm on the mar-
kings.
3. Insert the 2 plugs (D) into the 2 holes and fix the 2 hooks (C) with 2 screws (D) to
the wall as shown in Figure 8.
A (mm)
410
550
690
830
970
B (mm)
E (mm)
93
140
93
280
93
420
93
560
93
700
EMISOR TÉRMICO C4/C6/C8/C10/C12 BLANCO
ENGLISH
F (mm)
495
495
495
495
495
31
Publicidad
