MSW -BS950S Manual De Instrucciones página 43

Aligning the work table at right angles to the blade
1. Raise upper blade guide fully. Check band saw blade tension.
A – Try square
2. Loosen locking screws.
3. Using a try square, set the table at right angles to the blade and tighten the locking screws again.
4. Loosen locking nut and adjust limit stop screw until it touches the working table.
A – Work Table
B – Limit Stop Screw
C – Locking Nut
5. Tighten locking nut.
3.3.7. Setting Up the Rip Fence
The rip fence is clamped to the front. It can be used on both sides of the blade.