MSW -BS950S Manual De Instrucciones página 48

Clean the equipment regularly with a damp cloth and some soft soap. Do not use cleaning agents or solvents; these could
attack the plastic parts of the equipment. Ensure that no water can seep into the device. The ingress of water into an electric
tool increases the risk of an electric shock. In order to extend the service life of the tool, oil the rotary parts once monthly. Do
not oil the motor.
3.5.1. Saw Blade Change
Danger! Risk of injury, even with the band saw blade at standstill.
Use only suitable band saw blades.
1. Loosen the 2 knurled screws and remove the U shape blocker.
2. Open both housing doors.
3. Loosen setting knob until the band saw blade has slackened.
4. To remove the band saw blade, guide it through the slot in the working table.
5. Fit fresh band saw blade. Ensure correct position: the teeth must point towards the front of the saw (where the doors are).
6. Center band saw blade on the rubber tyres of the band saw wheels.
7. Tighten setting knob until blade does no longer slip off the band saw wheels.
8. Close both housing doors.
9. Tension band saw blade; Align band saw blade and align blade guides; let saw test run for at least one minute; Stop saw,
unplug and recheck settings.